INSTALLATION MANUALAPPLICATION:FA D10 125G (125gph @ 45psi)Cummins 5.9L 12 Valve*with P7100 Injection pump***bypassing the factory lift pump**1994-199
C. Disconnect the factory suction and return line. The factory lines are re-moved by pressing in on the two tabs located in the connect
I. Before drilling marked location, clean area of debris. Using the photo, double check area selected for any interference including the fuel level
P. Connect factory wire harness to the fuel module along with the factory fuel lines. O. Route fuel line over the frame rail while rei
B. Secure THB-1001 to bolt on bracket with the RS 1002 and the (2)– 1/4-20x1 bolts, 1/4 washers, and 1/4 nuts. With the (4)-1/4-20x1.75” bolts thr
D. Slid the FASS pump into mounting brackets with the weep hole facing down. Torque (4) bolts to 110 inch pounds. VERY IMPORTANT: REMEMBERING THE
A. Route fuel line to the suction port on the FASS pump labeled “T”. Cut the fuel line. Insert PL-1005 into fuel line using oil. At-tach
F. Attach the PL-2003 to DIPF-1003. Torque to 18 ft./lbs. G. Remove banjo bolt connecting the outlet line of the factory fuel filter. This is the
The preset pressure is approximately 45 psi. Follow these steps to check or reset the fuel pressure. The port with 1/8” Allen plug marked with the l
Disclaimer: To help insure you receive the proper system and customer support at the local level, FASS has a VIP and Authorized Dealer network rep
Dear Valued Customer, “Made in the USA” is not just a slogan at FASS; it’s what we live by! FASS is not only assembled in the USA but 98%+
FASS Recommended Application FA D10 125G Cummins (12 Valve) 1994-1998 with stock - moderate horsepower modifications Note: Due to the increase
(FA D10 125G) (FA D10 125G) INSTALLATION MANUAL Follow these steps to ensure a simple installation of your new FASS ADJUST
125 GPH 45 PSI (Approximately) Adjustable Fuel Pump Series A fuel pressure gauge is highly recommended to identify fuel filter life and to prevent
Contents FL-1002 x14’ WH-1005 FPB-2005 BHB-1001 THB-1001 FF-3248 MP-9037
HC-1001 10-300 PL-1005 Ring Terminal BHF-1002 PL-1004 ST-1005Px16” BHN-1001 OR-223 LW-1001 DIPF-1004 RS-1002 1/2” Plug PL-2003 *Cable Ties* 46044 M
C. Crimp the ring terminals to the red and green wires of the WH-1005 Wire Harness. Attach red wire to the positive terminal of the battery
E. If fuse panel is located in the cab it will be necessary to guide the single red wire from the relay through the fire wall grommet to access t
Commentaires sur ces manuels