Fass T D10 125G Manuel d'utilisateur

INSTALLATION MANUALAPPLICATION:T D10 125G (125gph @ 45psi)Cummins 5.9L 12Valve*with P7100 Injection Pump*1994-1998 **Note: Cab and Chassis may require

C. Disconnect the factory suction and return line. The factory lines are re-moved by pressing in on the two tabs located in the connecting harness.

M. With proper length being obtained, place the assembly into the drilled hole securing the assembly using the lock washer & nut. Loc

B. For fitting purposes. Secure PBR-2001 to pump assembly lightly with (3) 1/4”-20x1 3/4 bolts and (3) WA-1001D. This will assembly will be

F. Connect factory plug into the FASS harness. Connect female plug of the FASS harness into pump. Turn key to “on”. With pump operat

H. Once secure use (3) 1 3/4 bolts and (3) WA-1001D spacers to mount the pump to the bracket. G. Assemble the FASS pump bracket PBR-2001 using th

I. Apply motor oil to gasket located on filters. Attach to system and hand tighten. Fuel Filter –Install FWS-3003 on side of pump with dr

A. Route suction line from the suction tube assy. to port ‘T’ on the FASS system. . Cut FL-1058 to needed length and insert P

Note: The Red Plastic Plugs located in the “H” ports can stay in place fuel will not flow through these ports. Coolant can be plumbed into these po

 Blow out any open lines/cover any open ports  Bolts and fasteners properly tightened?  Electrical harness and fuel lines secured and properly

Disclaimer: To help insure you receive the proper system and customer support at the local level, FASS has a VIP and Authorized Dealer network rep

Dear Valued Customer, “Made in the USA” is not just a slogan at FASS; it’s what we live by! FASS is not only assembled in the USA but 98%+ of

Serial # FASS Recommended Application T D10 125G Cummins 1994-1998 with stock - extreme horsepower modifications Note: Because of the higher

(T D10 125G) (T D10 125G) INSTALLATION MANUAL Follow these steps to ensure a simple installation of your new FASS TITANIUM

Titanium Series 125 gph 45 PSI (Approximately) A fuel pressure gauge is highly recommended to identify fuel filter life and to prevent engine dama

WH-1005 MP-9031 PBR-2001 FL-1002 x15’ FL-1056 x3’ PFB-2002 Contents FL-1058 x3’

*WE-1001* 46044 Mounting Package Contents PL-2003 HC-4001 10-300 Ring Terminal DIPF-1004 BT-14x03 CP-1003 HB-14516 PB-14316 PL-1005 10-302 4 Hex

C. Crimp the ring terminals to the red and green wires of the WH-1005 Wire Harness. Attach red wire to the positive terminal of the battery

E. If fuse panel is located in the cab it will be necessary to guide the single red wire from the relay through the fire wall grommet to access t